Loading...
Testing the System: WARNING- Matches, candles open flame or other sources of ignition should not be used for leak testing. CAUTION- It is recommended that leak testing be done using non-corrosive gas leak detection fluid (such as Big Bubbles gas leak ). Dish washing detergent, bath soap or other house hold chemicals that contain chlorides should not be used. Turn on the gas. Apply enough solution to each threaded joint (including the connector) so that it covers the entire circumference of the joint. Hold a towel or rag under the joint to catch any spill-over. If there are any leaks, bubbling will appear at the joints. Use a small mirror to view obscured areas. Never loosen the connection. If leak is not remedied by tightening, remove fitting, reapply pipe thread sealant or Teflon® tape, reinstall and reset. Some leak detection solutions may cause corrosion. After testing, thoroughly rinse all joints with water and dry. More help at www.fixitnow.com

Tags

Loading...

0 Comments